Baumit

Ideas with a future.

Product Information

Baumit GalaFix plus

Baumit GalaFix plus

(Efflorescence-free middle-bed adhesive for clinker, natural and artificial stones)

Lime efflorescence-free, sulphate-resistant medium bed mortar for the setting in or laying of clinker, natural and artificial stone or when working with Baumit GalaDrain Plus plus for powerful adhesion.

More information:


PRODUCT HIGHLIGHTS

  • Efflorescence-free

  • Sulphate-resistant

  • Frost-resistant

Your questions

Last question:


Expert answer:

Ask a question See more

The substrate must be evenly absorbent, dry, clean, dust-free, homogeneous, solid as well as frost-free (> +5°C).

Step 1: The substrate must be evenly absorbent, dry, clean, dust-free, homogeneous, solid as well as frost-free (> +5°C).

    • The substrate must be evenly absorbent, dry, clean, dust-free, homogeneous, solid as well as frost-free (> +5°C).

      Step 1: The substrate must be evenly absorbent, dry, clean, dust-free, homogeneous, solid as well as frost-free (> +5°C).

    • 


Add approximately 6.0 to 6.5 lts. of water and mix together with one sack of Baumit GalaFix plus using a suitable agitator until it reaches a stiff-plastic consistency.

      Step 2: Add approximately 6.0 to 6.5 lts. of water and mix together with one sack of Baumit GalaFix plus using a suitable agitator until it reaches a stiff-plastic consistency.

    • After approx. 5 minutes and another mix, GalaFix plus is ready to use. To achieve composite, proper support apply Baumit GalaFix plus to the entire underside of the slab prior to laying - about 2 to 3 mm thick and ridge using a square-notch trowel.

      Step 3: After approx. 5 minutes and another mix, GalaFix plus is ready to use. To achieve composite, proper support apply Baumit GalaFix plus to the entire underside of the slab prior to laying - about 2 to 3 mm thick and ridge using a square-notch trowel.

    • If adhering directly to concrete substrates in outside areas, ensure the slabs are laid with no voids (by using the

      Step 4: If adhering directly to concrete substrates in outside areas, ensure the slabs are laid with no voids (by using the "buttering-floating" method). Before laying, apply a thin, full-surface coat of mortar to the clean, dust-free underside of the slab, then position in the prepared grooved bed and tamp down.

    • Contact surface/coverage: inside: at least 65 %, outside: at least 90 %. Apply the prepared mortar within 3 hours. Note: Baumit GalaFix plus has been produced using the special cement  Slagstar®  and must not be mixed together with any other binding agents (Portland cement, construction lime etc.).

      Step 5: Contact surface/coverage: inside: at least 65 %, outside: at least 90 %. Apply the prepared mortar within 3 hours. Note: Baumit GalaFix plus has been produced using the special cement  Slagstar®  and must not be mixed together with any other binding agents (Portland cement, construction lime etc.).